Table of Contents
Advertisement
'
CA-MXS 3BK
Connecting the Speakers
MAIN SPEAKERS
CAUTION:
SPEAKER IMPEDANCE
6 OHMS.
RIGHT LEFT
For each speaker connect one end of the speaker wire to the speaker terminals
on the back of the CA-MXS3BK and one end to the speaker. On the back panel:
1. Open each terminal.
2. Insert the end of the speaker wire as shown (be sure to remove the insulation at the
end of each wire first).
3. Close the terminals to clamp the speaker wires firmly in place.
4. Connect the red (+) and black (-) terminals of the right side speaker to the red (+) and
black (-) terminals marked RIGHT on the CA-MXS3BK.
Connect the red (+) and black (-) terminals of the left side speaker to the red (+) and
black (-) terminals marked LEFT on the CA-MXS3BK.
IMPORTANT:
Match the polarity of the speaker terminals with the polarity of the
terminals on the CA-MXS3BK, red (+) to red (+) and black (-) to black (-). Check your
speakers for correct impedance: Main speakers 6 ohms only, surround speakers 16 ohms
Gals
Set this selector to either PHONO or AUX.
For a Record Player, set to PHONO;
for
P
ae
.
others, set to AUX.
Connecting Auxiliary Equipment
IMPORTANT
;
Make sure that the power is turned off
before setting this selector.
VTR
VTR
Pre
ee
Record Player
Record Player
a
Use MM-Cartridge-type Player only.
When recording an AM (LW/MW) broadcasting
program, beat sounds may be heard and recorded.
Set the BEAT CUT selector to either ! or 2, so
that beat sounds will not be heard nor recorded.
Page 4
(No. 20373)
1-7
Advertisement
Table of Contents
