Advertisement
WARNING! In order to avoid overheating, DO NOT cover the heater.
‰
DO NOT use the heater without the grille fitted.
8
DO NOT use if the heater has been dropped.
8
DO NOT use if there are visible signs of damage to the heater.
8
DO NOT touch the heater casing or grille when first switched off, as these will be very hot and will take time to cool.
8
NOTE: Children of less than 3 years should be kept away unless supervised continuously.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and
vulnerable people are present.
2.
INTRODUCTION
Features PTC heat conducting ceramic elements to achieve an instant, odour-free heat. Ambient room thermostat maintains
temperature at a preset level. Ideal for industrial applications with two heat settings or fan only. Supplied with power cable and 3-pin plug.
3.
SPECIFICATIONS
Model No: ...................................................PEH2001.V2
Fuse Rating:..............................................................13A
Heated Area: ........................................................... 40m
Output: ..........................................................6,800Btu/hr
Plug Type: ......................................................... 3-Pin BS
Power Supply Cable Length: ................................... 1.3m
Power: .........................................................1000/2000W
Supply: .......................................................... 230V - 13A
IMPORTANT! This unit is designed to raise the ambient temperature of an entire room, the temperature of the air coming out of the
front of the heater will be warmer than the general temperature of the room, but there may not be a significant increase due to the large
volume of air passing over the element. For the same reason, the element is hot during operation, but does not glow visibly. The room
temperature depends on room size, insulation and the ambient temperature, which will increase as the room gets warmer.
4.
OPERATION (FIG.1)
4.1.
Position heater in an upright position on a firm surface and at a safe distance from any obstructions, flammable substances etc. Keep
to a minimum of 0.5m clearance at the rear and sides, and 2m clearance at the front.
4.2.
Connect the heater to a suitable mains supply.
4.3.
Set the thermostat dial to the maximum setting (fully clockwise).
4.4.
The heater will switch on when the power setting selector is set to one of the two power settings.
4.5.
Once the room reaches the required temperature, turn the thermostat dial slowly counter-clockwise until the thermostat clicks, leave
the dial in this position and the room temperature will be maintained at this setting. The heater will continue to operate until the power
switch is turned to the OFF position.
4.6.
For fan only operation, turn the power/fan selector to the fan only setting and set the thermostat to its minimum setting.
4.7.
When not in use, disconnect the heater from the mains supply. Store it in a safe, dry, childproof location.
FIG.1
Off
Full Power
5.
MAINTENANCE
WARNING! Before attempting any maintenance, ensure that the unit is unplugged from the mains power supply and that it has cooled down.
‰
Clean the heater with a soft dry cloth only. DO NOT use abrasives or solvents.
5.1.
5.2.
Periodically check the heater grille to ensure that it is not blocked.
5.3.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
a hazard.
© Jack Sealey Limited
3
Fan Only
Half Power
Original Language Version
Thermostat
PEH2001.V2
Issue 2 (1,F)
08/11/23
Advertisement
