Advertisement
HOW TO HANDLE
YES
NO
The panel can be supported by the edge but
The panels should not be gripped by the ends and
only by keeping it vertical and without exerting
especially by the corners, to prevent them from
excessive pressure on the cells.
flexing too much under their own weight.
CONTENT OF THE KIT
CHARGE CONTROLLER
SOLAR PANEL
CABLES
ACCESS THE INSTALLATION MANUAL
IMPORTANT
SCAN THE QR CODE
YOU CAN FIND THE S/N ON THE BACK OF
THE PANEL AND ON THE BOX.
KEEP IT FOR THE WARRANTY
OR GO TO:
https://bit.ly/SunBender_manual
F F AC SIMILE
AC SIMILE
SOL00000000
SP00000000000
Advertisement
Table of Contents
Summary of Contents for Solbian SunBender solar Kit
- Page 1 HOW TO HANDLE The panel can be supported by the edge but The panels should not be gripped by the ends and only by keeping it vertical and without exerting especially by the corners, to prevent them from excessive pressure on the cells. flexing too much under their own weight.
- Page 2 HOW TO CONNECT drip loop* *please make a drip loop! Water could run along the wires and cause water damage of the charge controller. Remove the caps from Connect cable A to the Connect cable B to the Connect the M8 ring Connect the battery to the monopole Junction charge controller...
Need help?
Do you have a question about the SunBender solar Kit and is the answer not in the manual?
Questions and answers