Troubleshooting; Wiring Diagram - Klarstein ENDURAHEAT MAX 30 Manual

EN
22

TROUBLESHOOTING

Problem
The heating indicator
light is off.
Water not flowing out of
the hot water outlet.
The water temperature
is too high.
Water leakage.

WIRING DIAGRAM

Reasons
Failures of the
temperature controller.
1.The water supply is
cut off.
2.The water pressure is
too low.
3.The inlet valve of water
supply is not open.
Failure of the
temperature control
system.
Problem of the seal at
pipe joints.
Fig. 7
Solutions
Contact the customer
care center.
1. Wait for restoration of
water supply.
2. Use the heater when
the water pressure is
appropriate.
3. Open the inlet valve of
water supply.
Contact the customer
care center.
Contact the customer
care center