Advertisement
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
1. Turn the Power Switch to the "OFF" position.
2. Connect the Coiled Hose to the Inflator Hose.
a. Pull back on the Collar of the
Coiled Hose's Coupler.
b. Firmly insert the Inflator Hose
Nozzle into the Coupler.
c. Release the Collar, which will
snap the Nozzle into place.
d. Pull lightly on both hoses to ensure
a proper connection.
3. Attach the other end of the Coiled Hose to the Air
Hose using the same method described in step 2.
4. If necessary, select a Nozzle Adapter and
thread Adapter onto Air Hose Nozzle.
5. Turn on the car engine.
WARNING! TO PREVENT SERIOUS
INJURY: DO NOT TOUCH POSITIVE AND
NEGATIVE CLIPS TOGETHER.
6. Attach the Clips on the Power Cord onto the 12V
automotive battery (not included) power source.
a. Connect the RED Clip of the Inflator to
the positive (+) terminal of the battery.
b. Connect the BLACK Clip of the Inflator to a
good ground source on the engine block.
WARNING! TO PREVENT SERIOUS INJURY:
Do NOT connect Black Clip to the
other battery terminal.
Note: Connect to a 12VDC power source only.
7. Make sure the tire valve stem is
clean and free of dirt.
8. Turn the Inflator Switch to the "ON" position.
Page 6
For technical questions, please call 1-888-866-5797.
9. Holding the Air Hose Nozzle, connect the Nozzle
to the valve stem of the item to be inflated.
10. Monitor the Pressure Gauge carefully
to avoid over-inflating the item.
11. Continue inflating until the recommended
pressure is reached.
12. Do not operate for longer than 40 minutes at
40 PSI or greater. Inflator will automatically
shut off to prevent overheating.
Note: If Inflator automatically shuts off, turn the
Power Switch to its "OFF" position. Allow Inflator to
cool for 20 minutes. If necessary, reset Circuit Breaker
by pushing down on the Breaker. Then, turn the Switch
to its "ON" position to resume work.
13. When finished, turn the Switch to the "OFF" position.
14. Remove the Nozzle from the object.
15. Verify pressure with a pressure gauge (not included),
then replace the valve cap where applicable.
16. If the pressure is low, repeat the
steps beginning with Step 8.
CAUTION! Do not inflate beyond the
manufacturer's inflation rating.
17. When finished, turn off the car
engine and remove Clips.
WARNING! TO PREVENT SERIOUS
INJURY: Do not touch the metal parts of
the Inflator and hoses during use.
18. Allow the Inflator to cool.
19. Disconnect hoses. Wipe down unit and
replace into the included storage bag.
20. Store in a clean, dry, safe location
out of the reach of children.
59624
Advertisement
