Table of Contents
Advertisement
Page 52
PICTORIAL 5-15
Refer to Pictorial 5-15 for the following steps.
( ) Install 6-32 speednuts over the four holes
in the bottom flanges of the receiver. Po-
sition the speednut with the round hole side
as shown in the inset drawing on Pictorial
5-15.
( ) Mount the receiver on the
inside of the
shield assembly with 6-32 x 3/8" screws.
Refer to Pictorial 5-16 for the following steps.
( ) Route the convergence bracket through the
large cutout in the chassis.
NOTE: Complete the following boxed-in step for
the Model GR -180 TV set only.
( ) Route the microphone through the large cut-
out in the chassis.
( ) Clip one of the automatic degaussing coil
leads on lug 1 and the other lead on lug 3 of
terminal strip AR. Refer to inset drawing #1.
CONVERGENCE
BRACKET
6-32x3/8" SCREWY
l
fib
TOP PICTURE'
TUBE SHIELD
PICTORIAL 5-16
Advertisement
Table of Contents
