LEDLITE LTWPEM User Instructions

User Instructions
Please read these instructions and retain them for future reference.
Important information:
It is recommended that this fitting is installed by a qualified electrician ensuring the installation
complies with current IEE wiring regulations & local building control.
• This product is designed for connection to a 220-240V mains supply.
• Only mount on level and stable surfaces.
• We cannot accept responsibility for any claims arising from a poor installation.
• Always switch off mains supply before installation.
• The light fitting is Class I and requires an earth connection.
SPECIFICATIONS:
Emergency Operation
Output Wattage 2.5W
Time
Emergency Onversion
Input Voltage 220-240Vac 50/60Hz
Time
Input Current (max)
40mA Test Function
Length x Width x
Output Voltage
30-210Vdc
Depth
Output Current 10 - 85mA Input Connection
Open Circuit Voltage Output Connection
310Vdc
Maximum Working
Maximum Case
310Vdc
Voltage Temperature
Ambient Temperature
IP Rating
IP20
Range
Input to Output
Double Insulation
Protection
FEATURES:
● For maintained or non-maintained emergency lighting systems
● Conforms to EN 61347-1 and EN 61347-2-7and EN 61347-2-13
● Wired between driver and LED module via internal plugs
● Voltage change-over threshold according to EN 60598-2-22
● Over 3 hours rated duration
● Replaceable internal LiFePO4 battery pack
● Over-charge, over-current, short-circuit and deep discharge protection for battery
● Test Button for a quick functional test
● Green charging status LED
● Constant power output
LTWPEM
Emergency Kit Add On
for use with LTWPLED Fittings
>3 h Battery Type
<1s Battery Capacity
Battery Voltage
Manual
Battery Charge
220 x 42 x 28mm
Voltage
Battery Charge
Male/Female Plugs
Current
Battery Discharge
Male/Female Plugs
Voltage
Battery Discharge
75°C
Current
Charging Time
0 to 50°C
Battery Life
INSTALLING LTWPEM EMERGENCY KIT INTO LTWPLED FITTINGS
1
Open the fitting by unclipping
the steel fastening clips and
IP20
0
lock them in 90 position.
5
Open the battery compartment
of the emergency case by
releasing the plastic clip.
PLUG & PLAY INSTALLATION INSTRUCTIONS
LiFePO4
1. Disconnect the driver from the power wires
18730
2000mAh
6.4V
7.5 Vdc
30-250 mA
5.8-7.4 Vdc
2a.Emergency Kit only - Connect the wires as per the diagram below:
400-500 mA
>24h
2 Years
2b. Emergency Kit + MW Sensor - Connect the wires as per the diagram below:
2 3
Install the Emergency kit at Lock the Emergency in
the position clearly marked position by rotating the plastic
(EM) on the geartray. holders on the geartray.
6 7
Plug in the wires as per the
Connect the battery plug and wiring diagrams below.
close the battery compartment. (Emergency and EM+Sensor)
Driver
EM
Driver
EM
MW
Driver
4
Install the green LED
indicator and test button
into the geartray.
8
Close the fitting and secure
the steel fastening clips.