Table of Contents
Advertisement
The descriptions in this manual are based on the buttons on the remote
control. Please read this manual carefully and use the TV correctly.
(Some buttons and services may not be provided depending on models
or regions.)
How to register the Magic Remote Control
To use the Magic Remote, first pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
the remote control.
* If the TV fails to register the Magic Remote, try again after turning the
TV off and back on.
How to deregister the Magic Remote Control
(Back) and
Press the
seconds, to unpair the Magic Remote with your TV.
(Home) and
* Press and hold the
more than 5 seconds to disconnect and re-register the Magic Remote
at the same time.
• It is recommended that an Access Point (AP) be located more than
0.2 m away from the TV. If the AP is installed closer than 0.2 m, the
Magic remote control may not perform as expected due to frequency
interference.
Using Always Ready
(Depending upon model)
You can operate the TV and connect to Bluetooth with direct voice
recognition while the power is off.
→
→ [General] → [Always Ready], setting [Enable the
*
function] to on.
* Pressing the
button while watching TV switches the screen to
[Always Ready] that is turned on, and pressing the
more turns the screen to [Always Ready] that is turned off.
* Press the
(Home) button or the
when the screen is in [Always Ready] that is turned on.
Wheel (OK) button to display the wallpaper when the
* Press the
screen is in [Always Ready] that is turned off, and press the
to watch TV.
Note
• Using Always Ready may increase energy consumption.
• For more information about the feature, refer to the
[Support] → [User Guide] → [Troubleshooting] → [Learn More
About Always Ready].
Wheel (OK) on
(Home) buttons at the same time, for five
(Q. Settings) buttons for
button once
(Back) button to watch TV
Connecting Smart Devices using NFC Tagging
NFC is technology that uses Near Field Communication (13.56 MHz),
allowing you to conveniently send and receive information without
separate settings. By bringing a smart device near the NFC-enabled
remote control, you can install the LG ThinQ app and connect the device
to the TV.
1 Turn on NFC in the smart device's settings. To use NFC with Android
devices, set the NFC option to enable 'read/write tags' in the smart
device's settings. The NFC settings may vary depending on the device.
2 Bring the smart device near the (NFC) on the remote control. The
required distance for NFC tagging is about 1 cm.
3 Follow the instructions to install the LG ThinQ app on your smart
device.
4 Retagging the smart device to the remote control allows you to
conveniently access various features on the connected TV through the
LG ThinQ app.
Note
• This feature is available for NFC-enabled smart devices only.
• This feature is only available if the remote control has an NFC logo.
Specifications
Bluetooth
NFC
*
* Only MR22GN
button
→
→
Specifications (MR22GN, MR22GA)
Frequency range
2,400 to 2,483.5 MHz
13.553 to 13.567 MHz
Output Power (Max.)
7 dBm
-13.27 dBuA/m @ 10 m
11
Advertisement
Table of Contents
