Led Code Chart; Stationary Mounting - Intex QS 200 Owner's Manual

LED Reading
00
01
02 - 11
12
90
91
92
93
"BLANK"
When Code "90" alarm is shown, ensure the timer of the filter pump is set
one (1) hour longer than the Saltwater System.
If the filter pump does not have a built-in timer, the filter pump needs to
be turned on/off manually every day.
SALTWATER SYSTEM STATIONARY MOUNTING
Some countries, especially in the European community, require the product to be secured to
the ground or to a base in a permanent upright position. Check with your local authorities to
determine if there is a regulation in your area regarding above-the-ground swimming pool fi lter
pumps. If yes, then the product can be mounted to a platform using the two holes located in the
base. See drawing below.
The product can be mounted on a cement base or onto a wooden platform to prevent accidental
tipping. The mounting holes are 6.4 mm in diameter. Total assembly must exceed 18kg.
SAVE THESE INSTRUCTIONS
(130GS) MINI SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 06/09/2022

LED CODE CHART

Definitions
Stand-By Mode (Start-up)
Minimum Operating Hour (1 hour remaining)
Operating Hours (2 - 11 hours remaining)
Maximum Operating Hours (12 hours remaining)
Alarm Code (Low Pump Flow / No Flow)
Alarm Code (Low Salt Level)
Alarm Code (High Salt Level)
Stand-By Mode (Operating Process finished)
No Power or "Power Saving Mode" waiting to start next
Saltwater System cycle.
IMPORTANT
52 mm
130
English
GS
Page 12