Advertisement
Quick Links
Advertisement
Related Manuals for Xantech XVCE100IR
Summary of Contents for Xantech XVCE100IR
- Page 1 INSTALLATION INSTRUCTIONS XVCE100IR Volume Control, Electronic, 100W, IR...
- Page 2 XVCE100IR Volume Control The XVCE100IR is a volume control that provides the touch and feel of an electronic device. With a high-value appeal, no mechanical rotating or sliding parts are used in this high-power volume control design. The XVCE100IR is rated to 100 Watts and provides 12 steps of volume control.
- Page 3 Installation, Notes, and Caution You will need at the very least, a 1/8” slotted screwdriver, a ¼” slotted screwdriver, wire cutters and wire strippers. The recommended speaker wire to be used is 16-gauge stranded copper speaker wire. For runs longer than 100 feet, we recommend 14-gauge stranded copper speaker wire.
- Page 4 Impedance Jumper Settings for Identical Impedance How to use the impedance jumper setting chart: 1) Determine the minimum amplifier impedance (typically either 4- or 8-Ohm). This information can usually be found next to the speaker outputs located on the receiver or amplifier. If in doubt, consult the receiver and/or amplifier instruction manual.
-
Page 5: Basic Connection
Basic Connection FIGURE 1... - Page 6 FIGURE 1 shows the most basic connection. A power supply must be connected to the XVCE100IR. The credit card remote (included) can still be used. However, no IR bus is established to control source components. The 781RG Power Supply should be connected to the XVCE100IR Volume Control as follows.
- Page 7 IR System Connection FIGURE 2...
-
Page 8: Speaker Connections
FIGURE 2 shows a more advanced connection. In this application, an IR bus is established. Now almost any remote control can be directed at the XVCE100IR to control the source components. XVCE100IR RJ45 PIN 6 (White/Green) PIN 8 (Brown) PIN 3 (Orange) -
Page 9: Other Connections
Other Connections Override: Allows Page/Doorbell signals to override the volume setting in the XVCE100IR. A HIGH signal will place the XVCE100IR into a preset volume level. To preset the volume level, find the desirable volume level with the up and down buttons. Press and hold the MUTE button. - Page 10 This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Xantech Corporation. Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.