Do you have a question about the XMG 1210 and is the answer not in the manual?
Questions and answers
Summary of Contents for Rondson XMG 1210
Page 1
PHONE MUTE MUTE MUTE MUTE MUTE MUTE MUTE SOLO SOLO SOLO SOLO SOLO SOLO SOLO 6 USB AUX TRE L MIX R USER MANUAL WW.RONDSON.COM RONDSON - 5 rue d'Apollo - Parc d'Activités de Montredon - 31240 L'UNION - FRANCE...
Page 2
SOMMAIRE Avant d'utiliser l'appareil, veuillez lire entièrement ce manuel. Canaux d'entrée stéréo............1-2 Section principale..............3-5 Alimentatio n................. 6 Schéma fonctionnel du système..........7 Schéma fonctionnel du système (avec lecteur mp3) .....8 ATTENTION : POUR RÉDUIRE LE RISQUE DE CHOC ÉLECTRIQUE. NE PAS RETIRER LE COUVERCLE. AUCUNE PIÈCE NON RÉPARABLE À...
Page 3
CANAUX D'ENTRÉE STÉRÉO 1, ENTRÉE MICRO ( XLR ) Connectez le microphone ici. Si vous utilisez un micro à condensateur, assurez-vous que l'alimentation fantôme est fournie en appuyant sur l'interrupteur situé en haut de la section maître. AVERTISSEMENT : Ne pas appliquer l'alimentation fantôme avant de connecter un microphone.
Page 4
CANAUX D'ENTRÉE STÉRÉO 8, LOW Contrôle la tonalité de basse fréquence de chaque canal. Réglez toujours cette commande sur la position 12', mais vous pouvez contrôler la tonalité des fréquences moyennes en fonction de l'enceinte, des conditions de position d'écoute et de l'état des auditeurs.
Page 5
SECTION PRINCIPALE 16, 2TRAK IN Cette prise doit être connectée à une platine à cassettes lors de la lecture. Cette prise doit être connectée à une platine à cassettes lors de l'enregistrement de la sortie mixte. 17, SORTIES DE MIXAGE ET INSERTIONS Les sorties Mix LEFT et RIGHT sont envoyées par les prises XLR en tant que signaux équilibrés.
Page 6
SECTION PRINCIPALE 27, BOUTON PREV/VOL Il s'agit du bouton de recherche en arrière et de réduction du volume du lecteur Mp3, appuyez une fois sur ce bouton pour rechercher le précédent, appuyez deux fois pour rechercher le précédent et le précédent et le précédent ;...
Page 7
SECTION PRINCIPALE 39, SOLO Appuyez sur ce commutateur pour régler le signal de sortie du lecteur Mp3 via la prise MONITOR/ PHONES. 40, INDICATEUR DE CRÊTE Le niveau de crête du signal du lecteur Mp3 est détecté, et l'indicateur PEAK s'allume en rouge lill�...
Page 8
ALIMENTATION 46, CORDON D'ALIMENTATION AC AC 220V 50~60Hz Vérifiez la source d'alimentation de AC 220V avant de procéder aux connexions. Le fusible sera coupé pour éviter tout problème. 47, INTERRUPTEUR D'ALIMENTATION Appuyez sur la touche (l). Lorsque vous voulez faire fonctionner l'appareil. La LED (VOIR NO,14) s'allume lorsque l'appareil fonctionne.
Page 9
--.------ --._T +48V �-------l► MON L REPLACE PHANTOM POWER MON R Zin-=2K MIX/L FADER Ft (POST) (AUX1) Zin .. 45K MIX/R (POST) (AUX2) � (PRE) (AUX1) DIRECT MONO CHANNEL (AL L SIMILAR) OUTPUT LEFî/MONO Zin "' 36K GAIN LF HF BALANCE FADER �...
Page 10
r- -- �- MON L REPLACE et----� MON R Zin-=2K MIX/L FADER (POST) (AUX1) Zin .. 45K MIX/R PEAK (+17dBu) (POST) (AUX2) DIRECT MONO CHANNEL (AL L SIMILAR) OUTPUT LEFî/MONO Zin "' 36K RIGHT n JMP3 (PRE) BUSAMPS, ETC . MONITOR &...
Page 11
CONTENTS Before operating, please read this manual completely. Stereo input channels ............... 9-10 Master sectio n ................11-13 Power input ................... 14 System black diagram ..............15 System black diagram(with mp3 player) ........16 CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER.
Page 12
STEREOINPUTCHANNELS 1, MIC IN PUT ( XLR) Connect Microphone here. If you are using a condenser mie, ensure phantom power is supplied by pressing the switch at the top of the master secrion WARNING:Do not apply Phantom Power before connecting a microphone 2, LIN E IN PUT LINE...
Page 13
STEREOINPUTCHANNELS 8, LOW Control the low frequency tone of each channel. Always set this control to the 12 0' clock position, but you can control the middle frequency tone according to the speaker, the conditions of listening position and listeners state. Clock wise rdtation of the control increase the level.
Page 14
MASTER SECTION 16, 2TRAK IN This jack is to be connected with cassette deck when playing back. This jack is to be connected with cassette deck when recording the mixed output. 17, MIX OUTPUTS&INSERTS The Mix LEFT and RIGHT outputs are sent from the XLR sockets as balancedsingal.
Page 15
MASTER SECTION 27, PREV/VOL- BUTTON This is the search backward and reduce volume of the Mp3 player button, push it once to search the previous one, push twice to search previous and previous and previous one; push it within 5 seconds it will reduce the volume of the Mp3 player.
Page 16
MASTER SECTION 39, SOLO Press this switch to set the signais from Mp3 player output via the MONITOR/PHONES jack. 40, PEAK IN DICATOR The peak level of the Mp3 player signal is detected, and the PEAK indicator lights red when the level reaches 3 dB below clipping.
Page 17
POWER IN PUT 46, AC POWER CORD AC 220V 50~60Hz Check the power source of AC 220V before connections When occur a problem on this appliance. The fuse will be eut off power to prevent form aproblem. 47, POWER SWITCH Push marked(l).
Page 18
--.------ --._T +48V �-------l► MON L REPLACE PHANTOM POWER MON R Zin-=2K MIX/L FADER Ft (POST) (AUX1) Zin .. 45K MIX/R (POST) (AUX2) � (PRE) (AUX1) DIRECT MONO CHANNEL (AL L SIMILAR) OUTPUT LEFî/MONO Zin "' 36K GAIN LF HF BALANCE FADER �...
Page 19
r- -- �- MON L REPLACE et----� MON R Zin-=2K MIX/L FADER (POST) (AUX1) Zin .. 45K MIX/R PEAK (+17dBu) (POST) (AUX2) DIRECT MONO CHANNEL (AL L SIMILAR) OUTPUT LEFî/MONO Zin "' 36K RIGHT n JMP3 (PRE) BUSAMPS, ETC . MONITOR &...
Need help?
Do you have a question about the XMG 1210 and is the answer not in the manual?
Questions and answers