Separate Audio Program (Sap) - Toshiba MW20FM1 Owner's Manual
Combination flat color television and video cassette recorder/dvd video player
Hide thumbs
Also See for MW20FM1:
- Service manual (99 pages) ,
- Owner's manual (77 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
recording and playback /
Separate Audio Program (SAP)
AUDIO SELECT
1-2
The VHS Hi-Fi audio system permits high fidelity recording of
MTS STEREO TV broadcasts.
When a MTS STEREO broad-
cast is received, "STEREO" will
appear on the screen and the
program can be viewed or re-
corded in stereo.
The Hi-Fi stereo recording proce-
dure is the same as for normal
recordings.
Note:
When using a CATV system, stereo TV programs may be
transmitted over a mono cable channel, in this case
"STEREO" will not appear and the sound will be in mono.
• AUDIO
SELECT
0
Output selection
When viewing an MTS stereo TV program, or playing a
prerecorded VHS Hi-Fi stereo videotape,
press AUDIO
SELECT to select how the audio will be heard through
the speakers. Normally set to the Hi-Fi stereo position,
this button can be set to the MONO position if the stereo
broadcast or videotape audio is of poor quality. The "R"
and "L" positions allow the audio from the Right or Left Hi-
Fi channel to be heard over both TV speakers. This
button has no effect when viewing a MONO videotape or
TV program. Each time when you press the button,
OUTPUT SELECTION
display appears on the screen for
several seconds. Refer to the chart below.
Your unit is fitted with a SAP broadcast system which enables
you to switch to a separate audio program when viewing a se-
lected channel.
This function applies only when the program is broadcast in multi-
languages through the SAP broadcast system.
Press MENU. Press t or _ to select"TV SET-
UP", then press ENTER.
MENU
SETUP
2
Press t or _ to select "SAP".
Then press
ENTER to select "ON".
Then press MENU
repeatedly until
the menu screen is cleared.
MENU
SETUP
r
Listening
to SAP
When the unit is turned on or a channel selection
is made,
make certain the letters "SAP" appears
on the screen.
This means that the "Separate
Audio Program"
broad-
casting is available.
OR
OUTPUT
SOUND HEARD ON BOTH
SELECTION
SPEAKERS
STEREO
STEREO
LCH
LEFTCHANNELAUDIO
R CH
RIGHTCHANNELAUDIO
MONO
MONO
o
O
<_
o
Notes:
• When playing back a tape that is not recorded in Hi-Fi stereo
mode, the audio will automatically be monaural.
• When listening to a VHS Hi-Fi video tape or MTS broadcast
through the VHF/UHF jack (Audio/Video cord not connected),
the sound will be monaural.
Advertisement
Table of Contents
