Hints For Care Of Washing - Zanussi ZT 938 Instructions For The Use And Care

pen the flap door of the filter
ompartment by pressing it inwards with
, finger at the hinged side (as shown in
ig. 12).
shift safety slider A (Fig. 13) until the
ed notch B (Fig. 13) disappears.
"urn the filter knob counterclockwise
ind pull the filter out (Fig. 14).
'lean filter thoroughly.
Refit the filter and turn the knob
'lockwise until the red notch reappears.
Hints for care of washing
powder dispenser
We recommend that the washing powder
jispenser is checked regularly to ensure
that it is clean and dry. Do wipe
dispenser after each wash.
Helpful tips
for washing
Here are some practical hints to enable
you to obtain the best washing results:
Use a low suds washing powder specially
made for washing machines.
An excessive formation of suds will
cause unsatisfactory operation.
The quantity of washing powder required
depends on the amount of laundry and
on how soiled it is. It may therefore be
necessary to vary the quantities
suggested in this book according to
experience.
To obtain the best results when washing
wool do not wash more than 2 lbs at
a time.
In order to get good results when washing
synthetic material use a maximum
washing load of 4 to 5 lbs.
If your water is hard it can be softened
by adding special products such as
«Calgon» to the washing powder in
compartment «b» (Fig. 11). These
products facilitate the action of the
washing powder and help to give better
results.
Clothes should be sorted according to
fabric type, degree of soil and colour
fastness.
Tears and open seams should be mended,
loose buttons secured, zippers closed and
laces or bets collected in a cotton bag.
Articles without a hem should not be
washed. Ensure packets are emptied and
spots of rust, paint, ink etc., removed
before washing.
Always turn off waters taps fully when
the machine is not in use, even if it is
plumbed in.
If, after commencing a wash, you find
that the wrong programme has been
selected, push the control knob fully in
turning the indicator knob clockwise to
the correct programme. Then pull control
knob fully out again.
13