Summary of Contents for KickAss KAFWL
- Page 1 P O W E R Y O U R A D V E N T U R E RECHARGEABLE FOLDING LED WORK LIGHT USER MANUAL KAFWL V1.1...
-
Page 2: Table Of Contents
TABLE OF CONTENT - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - NOTES REGARDING THE INSTRUCTIONS NOTES REGARDING THE INSTRUCTIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -... -
Page 3: Notes Regarding The Instructions
NOTES REGARDING THE INSTRUCTIONS Warning of electrical voltage This symbol indicates dangers to the life and health of persons due to electrical voltage. Warning This signal word indicates a hazard with an average risk level which, if not avoided, can result in serious injury or death. Caution This signal word indicates a hazard with a low risk level which, if not avoided, can result in minor or moderate injury. -
Page 4: Safety
SAFETY General LED Work Light Safety Warnings Read all safety warnings, instructions, illustrations and specifications provided with this LED Work Light. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction... - Page 5 ● When operating a LED Work Light outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. ● If operating a LED Work Light in a damp location is unavoidable, use a residual current device (RCD) protected supply.
- Page 6 LED Work Light is maintained. Intended use Use the device, KAFWL Rechargeable Folding LED Work Light, according to the technical data and only for a temporary illumination of indoor and outdoor areas, e.g. for construction sites.
- Page 7 Residual risks Warning of electrical voltage Electric shock from insufficient insulation. Check the device for damages and proper functioning before each use. If you notice damages, no longer use the device. Do not use the device when the device or your hands are damp or wet! Warning of electrical voltage There is a risk of a short-circuit due to liquids penetrating the housing! Do not immerse the device and the accessories in water.
-
Page 8: Information About The Device
INFORMATION ABOUT THE DEVICE Device Description The device, KickAss Rechargeable Folding LED Work Light, is equipped with light-intense surface LEDs. You can select between a high or low brightness level for this device. Moreover, you can select the strobe mode. In the strobe mode, a flash effect can be created which can serve as warning, marking or defence function. -
Page 9: Technical Specifications
What’s Included 1 x LED work light with integrated battery 1 x Manual 1 x USB charging cable 1 x Warranty card TECHNICAL SPECIFICATIONS General Information Surface LED Light Bulb Power input COB LED 800LM Battery 4000mAh Rechargeable Luminous flux 800 lm Lithium Battery Burn time... -
Page 10: Transport And Storage
TRANSPORT AND STORAGE Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. Transport To make the device easier to transport, it is fitted with a transport handle. Before transporting the device, observe the following: ●... -
Page 11: Start Up
Storage Before storing the device, proceed as follows: ● Switch the device off. ● Pull the USB charging cable out of the device. ● Allow the device to cool down. ● Remove the batteries from the device. ● Clean the device as described in the Maintenance chapter. When the device is not being used, observe the following storage conditions: ●... - Page 12 > The device KickAss LED Work Light is now ready to use. Note Note that the battery status of the device KickAss LED Work Light cannot be read while in operation. You can only read the battery status while charging.
-
Page 13: Operation
● Use the devices only for a temporary illumination of indoor and outdoor areas, e.g. for construction sites. ● The KickAss LED Work Light can be used as a strobe. ● The LED work lights are particularly suited for illuminating larger areas. - Page 14 Using the power bank If you like to use the device KickAss LED Work Light as power bank, proceed as follows: 1. Put the USB charging cable (9) into the USB connection/ output (4) of the device KickAss LED Work Light.
Need help?
Do you have a question about the KAFWL and is the answer not in the manual?
Questions and answers