Table of Contents
Advertisement
GND terminal
Frame ground. When using a number of units together, connect the
GND terminals together.
INTERFACE CONNECTOR (SCSD
Connect to the host computer using the supplied SCSI cable. The other
connector can be used for a daisy-chain connection to another SCSI
device (hard disk drive, CR-ROM drive, etc.). If no other device is
connected, be sure to fit the supplied SCSI terminator.
CONTROL I/F OUT connector
When daisy-chaining to other'CDW-900E or CDW-W1 units for
simultaneous data writing, this outputs the control signals (START,
STOP etc.) to the next unit.
CONTROL IF IN connector
When daisy-chained to other CDW-900E or CDW-W1 units for
simultaneous data writing, this inputs the control signals START,
STOP etc.) from the previous unit.
DIGITAL OUT connector
When playing back a disc, this outputs a signal of digital audio
interface type 2, form | format.
Introduction
11°
Advertisement
Table of Contents
