Table of Contents
Advertisement
The timbres on the panel are allotted to Channels 1 through 9 and to 11.
(Refer to "Local Control" below for the timbres for Channels from 12
through 16.)
* The MULTI TIMBRE mode is off when the power is turned on.
(4) Leave the programming mode. (See p. 5.)
D.LOCAL CONTROL
The timbres allotted to Channels from 12 through 16 cannot be chosen
with the TONE SELECTORS on the panel. When you want to play in
these timbres with the digital piano's keyboard (without using an
externally connected MIDI instrument), you must first turn off the LOCAL
CONTROL explained below.
(1) Make sure that the piano is in the programming mode. After
turning off the MULTI TIMBRE mode, press the E. PIANO switch.
The flashing LED will change from PIANO2 to E. PIANO.
This mode is used to set whether the sound from the piano's keyboard
will be played or not, and is called the LOCAL CONTROL ON/OFF
mode. When set like this, no sound will be played when the keys are
struck.
(2) Press the highest white or black key to run LOCAL CONTROL on
or off.
White key (ON): The piano will output sound when the keys are struck.
Black key (OFF): Sound will be output only when MIDI data is received,
and not when the keyboard is played.
* You can also turn this on by turning the power off and then on
again, instead of using the highest key as described above.
18
Advertisement
Table of Contents
