X10 SUPERREMOTE UR24A Owner's Manual page 18

2. 2. 2. 2. 2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
the Setup button.
3. 3. 3. 3. 3. Use the number
buttons to enter the
number equivalent
to the chosen
House Code (1=A,
2=B ..16=P).
4. 4. 4. 4. 4. Press the ENTER
button to confirm
the House Code.
The LED turns off.
Note: The Housecode you choose must
match the Housecode on the Transceiver
Module you are using it with.
3 4 3 4
3 4 3 4 3 4
C C C C C
ONTROLLING ONTROLLING AN AN
ONTROLLING AN ONTROLLING ONTROLLING AN AN
IR M IR M IR M IR M IR M C C C C C (IR543) (IR543) (IR543) (IR543) (IR543)
INI INI INI INI INI ONTROLLER ONTROLLER ONTROLLER ONTROLLER ONTROLLER
If you already own an IR Mini Controller,
you will need to change the X10 Home
Automation code in the remote to use it.
The code for standard X10 Home
Automation is 013. The code to control
the IR mini controller is 014. To change
the code:
1. 1. 1. 1. 1. Press and hold
SETUP until the LED
indicator lights
steadily. Release
the SETUP button.
2. 2. 2. 2. 2. Press and release
the X10 button.
3. 3. 3. 3. 3. Enter 014 to control
an IR Mini
Controller, 013 for
standard X10
control. The LED
turns off after the
last digit entered.
Note: In most cases, you will not need
to use the IR Mini Controller to receive
commands from the UR24A Learning
SuperRemote - the Transceiver Module
does this for you and has the added
advantage of working through walls. You
can't control the IR Mini Controller and
the Transceiver Module at the same time.
3 5 3 5
3 5 3 5 3 5