Table of Contents
Advertisement
Operator Apps
HD+ OpApp
HD+ OpApp
HD+ OpApp* is an app provided by HD+ for Germany
users that can run a virtual set-top box on TV. The app
has the applications and features that you previously
needed a physical set-top box to access.
You need internet connection and accept the Philips
Terms of Use, the Privacy Policy and Smart TV Terms of
Use to install the HD+ OpApp. You can install the App
either using the Apps Screen or the Search for satellites
option in the Settings Menu.
If the HD+ OpApp cannot be downloaded or installed,
you may try to download again later. If problem persists,
please contact HD+.
Once the HD+ OpApp has been installed successfully,
you can start the free period. Please switch the source to
Watch Satellite after the installation. If you have been
using a CAM Module for HD+ before, you can remove it
now. If a CICAM is inserted in the TV, it will not be used
to descramble the signal when you are watching a
satellite channel.
After HD+ OpApp is installed, there are some features
will be affected.
• Recording and reminder functionalities are not allowed
for satellite channels.
• Favourite list is only available in Antenna/Cable.
• The channel selection, TV Guide, channel information
are replaced by the OpApp user interface
• Satellite channels renaming and cloning will be
disabled.
* Note: HD+ OpApp is only available for HD+ subscriber
and the country setting is Germany.
Channel List Copy
Introduction
Channel list copy and Satellite list copy are intended for
dealers and expert users.
With Channel list copy/Satellite list copy, you can copy
the channels installed on one TV onto another Philips TV
of the same range. You can avoid the time-consuming
channel search by uploading a predefined channel list on
a TV.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the
hardware type on the TV type plate on the back of the
TV.
• Both TVs have compatible software versions.
• Use a USB flash drive of minimum 1 GB.
Copy a Channel List, Check Channel List Version
Copy a channel list to USB flash drive
To copy a channel list...
1 - Switch on the TV. This TV should have channels
installed.
2 - Plug in a USB flash drive to USB 2* port.
3 - Select (Home) > Settings > Channels > Channel list
copy or Satellite list Copy and press OK.
4 - Select Copy to USB and press OK.
5 - When copying is done, unplug the USB flash drive.
Now you can upload the copied channel list onto
another Philips TV.
* Note: only the USB port that marked with USB 2
supports copying channel list operation.
Check channel list version
(Home) > Settings > Channels > Channel list copy or
Satellite list Copy > Current version
Upload a Channel List
To not Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and
select language and country. You can skip the channel
search. Finish the installation.
2 - Plug in the USB flash drive that holds the channel list
of the other TV.
3 - To start the channel list upload, select
(Home) > Settings > Channels > Channel List Copy or
Satellite list Copy > Copy to TV and press OK. Enter your
PIN code if necessary.
4 - The TV notifies you if the channel list is copied to the
TV successfully. Unplug the USB flash drive.
To Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this
setting, see Reinstall channels section. Start this
procedure until you reach the country setting.
Press Back to cancel the installation.)
If the country is correct continue with step 2.
If the country is not correct, you need to start a
reinstallation. See Reinstall channels section and start
21
Advertisement
Table of Contents
