Summary of Contents for HYDRAGUN HeatPulse
- Page 2 In the box, you’ll find: HeatPulse Knee Massager Manual (comprising custom-fit sleeve and detachable control pod) Extension strap USB-C (for using the HeatPulse on the shoulders) charging cable...
- Page 3 Specifications Control pod Sleeve 360° Silkro™ fabric Magnetic back Breathable, moisture-wicking polyester mesh lining Top strap: 51cm (20") Bottom strap: 48cm (19") Extension strap: 58cm (23") HeatLast™ infrared Control pod graphene band with dual vibrating Battery capacity: cores 1600mAh 7W 5V Battery life: 60-90 minutes Silkro™...
-
Page 4: Getting Started
Getting started Find your fit Strap the sleeve around your knee. It should fit snugly—not too loose or too tight. Attach the control pod Attach the magnetic control pod to the sleeve. The control pod may be attached the right side up or upside down. If an "E2"... - Page 5 Turn on the control pod Press and hold the power button for three seconds. This will activate the HeatLast™ infrared graphene heating band which will start to warm to 40°C (104°F) Select your temperature Push the + button to gradually increase the temperature until it is right for you.
- Page 6 Select your massage speed If you wish to turn on the HeatPulse’s massage function, press and hold the M button for three seconds. Push the M button again to cycle through the three speed settings until you find the one that’s right for you.
- Page 7 Once you’ve selected your settings, sit back and let the HeatPulse work its magic. One full treatment session lasts for 30 minutes, after which the HeatPulse will shut off automatically. (To end your treatment mid-session, press and hold the power button for three seconds.) Repeat the treatment session on the other knee if desired.
- Page 8 Charging M button will display a The recommended charging time Do not operate the HeatPulse flashing green light is two to three hours for a full while it is charging. charge. Frequent overcharging...
- Page 9 Caring for your HeatPulse >0% Control pod Wipe down with a slightly damp or dry cloth. Make sure the pod is completely dry before attaching it to the sleeve and turning it on. Sleeve Wipe down with a slightly damp cloth or sanitize with alcohol sprays or wipes.
- Page 10 When to use your HeatPulse The HeatPulse is designed for: Knee arthritis Relieve chronic knee stiffness and pain Improve blood flow to ease age-related joint tension and increase flexibility Knee injuries and Speed up healing of acute knee pain post-surgery recovery...
- Page 11 To maintain the health of your knee joint, boost recovery and keep pain away, use the HeatPulse On elbows Strap the HeatPulse onto your Knee Massager once or elbows, ensuring that it is snug twice daily on both knees but not too tight.
-
Page 12: Safety First
Safety first If you feel pain or extreme discomfort, Do not use the HeatPulse over thin or notice any skin issues or irritation fabrics like stockings. For best results, around your knee while using the use it directly on the knee and not over HeatPulse, stop using it immediately other fabrics. - Page 13 Consult your physician before using the HeatPulse if any of the following applies to you: • Nerve disorders in the leg • Skin sensory disorders Do not use while under quilts • Loss of sense of temperature or blankets as this may cause •...
- Page 14 Take your HeatPulse experience to the next level Round out your recovery routine—use the HeatPulse Knee Massager with these complementary products: The Thermosleeve Try hot and cold contrast therapy for comprehensive knee pain relief: A 360° Hot/Cold Compression Sleeve that uses Hot or Cold...
- Page 15 The Hydragun Try the Hydragun for whole-body relief and relaxation: Named “The Quietest Massage Gun” by Forbes, GQ, TechRadar and many more, the Hydragun uses percussive therapy to knead away tight knots and aches on targeted muscles. Use the HeatPulse on the...
- Page 16 hydragun.com...
Need help?
Do you have a question about the HeatPulse and is the answer not in the manual?
Questions and answers