Advertisement
®
Vernier Go Direct
Charge Station
Order Code GDX-CRG
PLEASE READ BEFORE USING PRODUCT!!
Please connect the included power supply to the GDX-CRG station
and wall outlet
BEFORE
connecting any Vernier sensors.
Charging Instructions
®
Connect one or more supported Go Direct
devices or Go Wireless sensors to
the Go Direct Charge Station. Charge the devices as recommended in each
sensor's user manual.
Charging Indicator
The charging indicator on each sensor is
used to determine the charging status for
that sensor. For charging LED behavior
specific to your sensor, refer to the sensor's
user manual.
Note: For wand-style sensors that fit into
the oval holes in the charging station,
verify each sensor shows its blue charging
indicator light
when first connected
to the
charge station (even if it is fully charged).
If it does not, there may be an issue with
the sensor. Contact Vernier's Support team
for additional assistance.
www.vernier.com/support/
1-888-837-6437
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vernier Go Direct GDX-CRG
Summary of Contents for Vernier Go Direct GDX-CRG
- Page 1 (even if it is fully charged). If it does not, there may be an issue with the sensor. Contact Vernier's Support team for additional assistance. www.vernier.com/support/ 1-888-837-6437...
- Page 2 Warranty Warranty information for this product can be found on the Support tab at www.vernier.com/gdx-crg General warranty information can be found at www.vernier.com/warranty Vernier Science Education 13979 SW Millikan Way • Beaverton, OR 97005-2886 Toll Free (888) 837-6437 • (503) 277-2299 • Fax (503) 277-2440 info@vernier.com •...
Need help?
Do you have a question about the Go Direct GDX-CRG and is the answer not in the manual?
Questions and answers