Advertisement
1. Installing CPU
This socket supports LGA-775 CPU, which is the CPU package developed by intel.
Other forms of CPU package are impossible to fitted in.
1. Pull CPU socket lever and plate up .
2. Remove plastic cap from CPU socket plate .
3. Locate Pin 1 in the socket and look for a golden arrow on the CPU upper interface .
Match Pin 1 and golden arrow . Then insert the CPU into the socket .
4. Press down CPU socket plate and lever to finish CPU installation .
CPU socket lever
Plastic cap
Note:
If you do not match the CPU socket Pin 1 and CPU golden arrow well, you may damage the CPU.
CPU Frequency Table
Processor
L2 Cache
Core 2 Duo E8400
6M
Core 2 Duo E6550
4M
Core 2 Duo E6850
4M
Core 2 Duo E7400
3M
Core 2 Duo E7200
3M
Core 2 Quad Q6700
4M*2
Pentium Dual-Core E5400
2M
* MCP7A support front side BUS 667/800/1066MHz.
Note:
With CPU speed changing rapidly, there might be faster CPU on the market by the time you
received this installation guide. This table is kindly for your references only.
4. Installing HDD Device
The motherboard provides three SATA connectors.
Connect SATA cable to the on board SATA connector. You can find SATA cable in our package.
(this is SATA signal cable) And please also connect 5V power connector with SATA power cable.
SATA Signal Cable
To Connect SATA Device
SATA Power Cord
To Connect SATA Device
5. JP14 Clear CMOS
You can clear CMOS to restore system default settings.
To clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR24.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR24.
JP14 Clear CMOS Jumper
1
1
Clear CMOS
Normal (Default)
Tip: When should I clear CMOS?
1. Boot fail .....
2. Forget password .....
3. Trouble shooting .....
CPU socket plate
Golden arrow
Socket pin 1
FSB
Speed
Ratio
Support BIOS Version
1333
3.0G
9
R1.00
1333
2.33G
7
R1.00
1333
3.0G
9
R1.00
1066
2.8G
10.5
R1.00
1066
2.53G
9.5
R1.00
1066
2.66G
10
R1.00
800
2.7G
13.5
R1.00
2. Installing Memory Module
The motherboard provide SO-DIMM type memory support. There're two SO-DIMM memory slots
which motherboard provided. The installation of memory module as below.
1. Put the memory module with correct direction. Notice there's one stick to make sure direction is
correct.
2. Plug in memory module into SO-DIMM slot with vertical 90º. Make sure memory module plug
into slot completely.
3. There're tabs which located in the side of SO-DIMM holder. Use finger to push memory module
vertically until the tabs lock memory module tightly.
4. Now, the memory modules have been plugged properly with horizontal flat.
3. Installing ODD Device
The motherboard provides three SATA connectors.
Connect SATA cable to the on board SATA connector. You can find SATA cable in our package.
(this is SATA signal cable) And please also connect 5V power connector with SATA power cable.
SATA Power Cord
To Connect SATA Device
SATA Signal Cable
To Connect SATA Device
Advertisement
