Product Certifications - SUNFORGE Genasun GVB-8-WP Series Manual

LITHIUM WARNING: Use caution when working with lithium systems. Genasun Li controllers use the CC/CV charging profile indicated on
the controller. CHECK the specifications of the battery pack to ensure that the CV voltage is correct. Further check that the power
by the solar array and Genasun controller is within the battery specified design limits.
LITHIUM BMS WARNING: Genasun recommends using a lithium battery with a Battery Management System capable of disconnecting the solar
charge controller in the event that any cell in the pack is outside of its rated temperature, current, or voltage range. Failure to do so may result in
property damage, injury or death. Genasun highly recommends the use of a BMS with cell balancing. Cell balancing is mandatory for lithium iron
phosphate. Use only copper conductors suitable for a minimum of 60 °C. If operation at high power or at high ambient temperatures is expected,
wire with a higher temperature rating may be necessary.

Product Certifications

EMC
Conforms to:
EN 61000-6-3:2007+A1:2011
EN 61000-6-2:2005
AS/NZS 61000-6-3:2012
Inspection & Maintenance
Inspect the controller at least once per year to ensure proper performance.
• Check for animal or insect damage.
• Inspect for corrosion / water damage.
• Inspect the security of all connections.
• Ensure the solar array does not exceed the maximum input voltage.
• Repair and clean as necessary.
EMC
Conforms to:
FCC (CFR Title 47) Part 15 Radio frequency
Devices, Subpart B - Unintentional
Radiators. Tested for compliance.
Restriction Hazardous Substances
Conforms to:
EN 50581:2012
supplied