Advertisement
1
WARNINGS AND GENERAL PRECAUTIONS
CAUTION! – This manual contains important instructions and warnings for personal safety. Carefully read all parts of this manual.
If in doubt, suspend installation immediately and contact Nice Technical Assistance.
CAUTION! – Important instructions: keep this manual in a safe place to enable future product maintenance and disposal pro-
cedures.
CAUTION! – Any use other than that specified herein or in environmental conditions other than those stated in this manual is
to be considered improper and is strictly forbidden!
The product's packaging materials must be disposed of in full compliance with local regulations.
Never apply modifications to any part of the device. Operations other than those specified may only cause malfunctions. The manufacturer
declines all liability for damage caused by makeshift modifications to the product.
Do not expose this product to moisture, water or other liquids.
This product is designed for indoor use only. Do not use outside!
This product is not a toy. Keep away from children and animals! CR2032 coin cell battery is harmful if swallowed!
2
PRODUCT DESCRIPTION
NICE Temp Control-EU is a wireless temperature sensor designed to use with NICE Heat-Control (FGT-001 ZW5 EU).
It allows for better temperature control by measuring reference temperature anywhere in the room.
Main features
Temp-Control is the only compatible temperature sensor with NICE Heat-Control (FGT-001 ZW5 EU)
Provide the best temperature regulation
One Temperature Sensor can be paired with up to three thermostatic heads.
3
BASIC ACTIVATION OF THE DEVICE
NICE Temp Control-EU should be placed in the same room or heating zone as the thermostatic head which will use it as a reference point for
the room temperature.
Before using, the sensor must be paired with the thermostatic head. One thermostatic head can be paired with only one sensor, but one sen-
sor can be paired with up to three thermostatic heads.
3.1 - Pairing Temp-Control with NICE Heat-Control
To pair the Temp-Control with the device:
1. Use a coin to open the battery cover by turning it counter-clockwise.
2. Remove the sticker underneath the battery.
3. Put battery into slot and close cover.
4. Press and hold the button on the thermostatic head.
5. Release the button when you see blue LED color.
6. Click the button to confirm the selection, the LED ring will start blinking blue.
7. Within 1 minute click the button on the Temp-Control using the included key.
8. The LED ring on thermostatic head will glow green to confirm successful pairing.
9. Place the Temp-Control in same room as the thermostatic head, no further than 5 meters from it.
3.2 - Removing Temp-Control from NICE Heat-Control
To remove all paired heads from the sensor's memory:
1. Press and hold the button on the sensor for 2 seconds.
2. The LED on the sensor will blink 3 times to confirm unpairing.
Advertisement
