Operation - Hyundai HY1300MP Manual

Need to identify safety measures to protect the operator that are based on an estimation of

exposure in the actual conditions of use (taking account of all parts of the operating cycle such
as the times when the tool is switched off and when it is running idle in addition to the trigger
time).
Wear hearing protection.


3. OPERATION

a. Assembly of bit
The tool must be switched off and unplugged when assembly a bit on the tool.
- Pull the grip rearward.
- Insert the bit in the hole on the front cover.
- Adjust the groove position while turning the bit, and furthermore insert it until it hits the end of
the hole.
- Release the grip. Pull the tool to make sure that it is locked completely.
b. Working position of bit
- If the grip is turned on the left, in the condition where the grip is pushed rearward, the bit angle
can be changed freely to any position (according the type of bit).
- Release grip and turn the bit, and make sure that it is locked completely.
c. Removing the tool
- Switch off and unplug the tool. Let it cool before.
- Push and hold the lock button rearward. Hold the bot and remove it.
d. Side handle
The side handle is already installed in the tool. You must fix it.
- Put the handle in desired position.
- Screw the handle in place to fix it.
e. Use
Be careful of hidden electrical lines or gas and water pipes. Check the working area, e.g. with a
metal detector.
Check the product, power cord and plug as well as accessories for damage before each use. Do
not use the product if it is damaged or shows wear.
Double check that accessories or application tools are properly fixed.
Always hold the product by its handles. Keep handles surfaces clean and dry to ensure safe
support.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary with a soft
brush. Blocked air vents may lead to overheating and damage the product.
Switch the product off immediately if you are disturbed while working with it and when other people
enter the working area. Always let the product come to a complete stop before putting it down.
Do not overwork yourself. Take regular breaks to ensure concentrated work and full control over
the product.
- Plug the tool to the supply mains.
- Apply the tip of the bit on the tool to be worked.
- Push the trigger switch to start the operation.
- In some cases, it is necessary to punch the tip of the bit against the object being worked on in
order to begin the striking stroke. This is not due to malfunction of the power tool. It means that
the safe guard mechanism against no-load striking is working.
- Operate this demolition hammer by utilizing its own weight.
07