Sony Cyber-shot DSC-T77 Instruction Manual page 5

Note:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio fl'equency energy and,
it"not installed and used in accordance with the
instructions, may cause harmflfl interlereuce to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, tile user is encouraged to
try to correct the interfizreuce by one or more of
the following measures:
Reorient or relocate tile receiving antenna.
Increase the separation between tile equipment
and receiver.
Connect tile equipment into an outlet on a
circuit different from that to which tile receiver
is connected.
Consult the dealer or an experienced radiofrV
technician fi_r help.
The supplied iuterlace cable must be used with the
equipment in order to comply with the limits lot a
digital device pursuant to Subpart B of Part 15 of
FCC Rules.
This product has been tested and found compliant
with tile limits set out in the EMC Directive for
using connection cables shorter than 3 meters
(9.8 llzet).
Attention
The electromagnetic fields at tile specific
fi'equencies may influence the picture and sound
of this unit.
Notice
It" static electricity or electromagnetism causes
data trausllzr to discontinue midway (fail), restart
tile application or disconnect and connect the
comnmnicatiou cable (USB, etc.) again.
[el.']