Tiger Games Lazer bounce 42024 Instructions

Pee eat ee 4. Remove batteries if product is not to be played
with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by,
local electrical interference, move it away from
other electrical equipment. Reset (switching off
and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these
with any other types of battery. Always remove
from the product before recharging. Recharge
batteries under adult supervision.
DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
ASS!
Assemble the game unit as shown in the illustrations below.
"IMPORTAN: Wii y Z
e If this game malfunctions or "locks up," use a ballpoint pen to press the RESET 1. Unfold the connecting arm and place it on the floor as shown,
button (shown later in instructions). If the game still doesn't function, remove
and replace the batteries with fresh ones.
e Please keep these instructions for future reference.
Requires 3 "AA" or LR6 SIZE BATTERIES (NOT INCLUDED)
Phillips screwdriver (not included) required to install batteries
To install the batteries, do the following:
2. Carefully attach a game unit section to each end of the connecting arm as shown
1. Use a Phillips head screwdriver to loosen the
below.
screw on the battery compartment door
(located on the back of the unit) and open
the door.
2. Insert 3 new "AA" size batteries, making
sure to align "+" and "-" as shown.
3. Replace the battery compartment door
and tighten the screw.
4. If this game malfunctions or "locks up," use
a ballpoint pen to press the RESET button.
Note: If connections are not properly made, the game will repeatedly beep when
the ON button is pressed, Shut the game unit off, and make sure all conections
are snug and correct.
3.Carefully pull out one string and
/\ CAUTION e TO AVOID BATTERY attach it to the opposite unit as
shown below. Then do the same
always follow the toy and battery manufacturers' Nets: when you are isn paying,
instructions; automatically retract into the unit.
2. Do not mix old batteries and new batteries or
alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the
product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
Z\ CAUTION: =
1. Always follow the instructions carefully. Use only ea
batteries specified and be sure to insert them /
correctly by matching the + and - polarity
markings.
2. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the
product.
LED STROBE
ON/OFF
SOUND
RESET
LED STROBE