Solight PP126USBC Quick Start Manual

EN
PP126USBC
Pop-up power socket with a cable
Thank you for purchasing our product. Please read this manual carefully and heed the safety warnings and instructions before installing, using or
repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.

Installation

- determine the position on the table where you want to insert the socket module. Installation is not recommended too close to the
edges to ensure the strength and load-bearing capacity of the board. If it is a chipboard table, tape the area around the position with
insulating tape. For a successful installation, there must be at least 20cm (200mm) of space under the top edge of the table or worktop
for the free movement of the power cable.
- mark and cut a hole with dimensions of min. 24.7 x 6.2 cm, max. 25.0 x 6.5 cm.
- Insert the pop-up block into the hole and push until it fits into the hole. Then, from below the table, put on the plastic locks and push
them to the maximum possible height so that the socket block does not move. Silicone or other mounting sealant can be used under
the top cover to ensure a firm fixation of the position and sealing against liquid leakage under the plate.
- Finally, plug the power cord into an electrical outlet.

Mains power

- 3x 250V~ socket, current load and total input max. 16A / max. 3680W at 230V~.
- Power supply cable PVC H05VV-F 3G 1.5mm2, length 2m (visible 1.9m).

QC 3.0 USB charging outputs

- 1x Type A - fast charging, charging current DC 5.0V-3.0A, 9.0V-2.0A, 12.0V-1.5A, max. 18.0W - single use.
- 1x Type-C - fast charging, charging current DC 5.0V-3.0A, 9.0V-2.0A, 12.0V-1.5A, max. 18.0W - single use.
- Type A + C - maximum charging current DC 5.0V-3.4A, max. 17.0W - common use.
- when two devices are plugged into both USB ports (Type-A and Type-C) at the same time, the intelligent circuit detects their batteries,
adjusts the charging current and changes the charging speed depending on their capacity and state of charge. The maximum charging
current is determined by the type of USB port, max. 3.4A together.
- the charging time corresponds to the number of connected devices, the capacity and state of charge of their batteries.

Use

- push the socket block to eject or retract it. The automatic latch is released or secured by pressure. The latch is located in the middle of
the longer side of the block, so it is recommended to press the center of the top cover with one hand or both palms evenly on the
larger surface of the top cover.
- the power cable under the table must be kept in a vertical direction (not at an angle) to ensure smooth movement of the pop-up block.
- connect the power or USB cables of appliances.
- working temperature: 0°C (32°F) – 35°C (95°F)
Do not change the internal connection, do not exceed the permissible load, clean only disconnected from the mains, let it dry thoroughly.
The company Solight Holding s.r.o. is in no way responsible for property damage and personal injury caused by unprofessional installation or incorrect
.
use

USB charging efficiency

Average active efficiency
Efficiency at low load (10%)
No-load power consumption
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Česká republika.
81.9%
72.5%
0.07W