Checking Recording Just Made; Sectional Erasure Of A Recording; Sectional New Recording - Siemens 2000 Service Manual

'"'·
Checking recordings just made
1. Set function switch h (Fig. 2 a) to
3 .
2. Run film in reverse to wanted section.
3. Run film forward and monitor recording by loudspeaker or with set of high-
impedance headphones.
Sectional erasure of a recording
1. Determine section to be erased by reference to frame counter or to scene
cue marks.
2. Run fi I m back past starting cue of the section to be erased.
3. Set function switch h (Fig. 2 a) to red
0
4. Sw itch on erase head (set sw itch e, Fig. 3 b, to
G ).
S. Turn record contro l f (Fi g. 3 b) counterclockwise as far as it will go (zero
position).
6. Switch o n projector and press button d (Fig. 3 a) of recording stage.
7. On reaching section to be erased, turn record cont ro l c lockwise as far as it
wil l go ( C ).
8. At the end of the section to be erased, turn record cont rol f counterclock-
wise as far as it wil l go.
9. Switch off projecto r.
Sectional new recording
1. No te set ting o f control for proper modulation of microphone and tone arm
(see Magnetic recording, section 4).
2. Proceed as in case of erasure of indivual sections.
16
On reaching the point where the new section is to beg in, turn record con-
trol f (Fig. 3 b) clockwise as far as it will go and volume control e or f (Fig. 2 a)
to position noted.
When the new section llas been added, turn record control counterclockwise
as far as it will go.