Table of Contents
Advertisement
Quick Links
Installation guide
TSE55-B Color Touchscreen
TSE40 Colour Touchscreen
Installation Instructions
Planning the Installation
TSE40 is designed to be wall mounted in
landscape orientation.
TSE40 requires a minimum mounting depth
of 1.86" (47mm) from the front wall surface
plus room for cable/s. TSE40 is designed to be
powered over an Ethernet connection (PoE), via
iCANnet
or an auxiliary power supply.
TM
There are two ways the TSE40 communicates
with an iCANnet
network.
TM
1. A hard wired Ethernet connection to a TSI-1 /
TSI-1-NA via a PoE Switch.
Or
2. Directly to iCANnet
TM
using iCANnet
cable.
TM
Overview
TSE40
Mounting Bracket
Standard UK Back Box
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for iLight TSE40
- Page 1 Standard UK Back Box landscape orientation. TSE40 requires a minimum mounting depth of 1.86” (47mm) from the front wall surface plus room for cable/s. TSE40 is designed to be powered over an Ethernet connection (PoE), via iCANnet or an auxiliary power supply.
- Page 2 Mounting height Mounting the TSE40 The recommend mounting height for the The TSE40 screen is designed to friction fit into TSE40 is 57 - 64in (145-165cm) above the its mounting bracket. Line the screen up with the finished floor to the center of the unit.
- Page 3 Connect the TSE40 using a standard CAT5E or CAT6 Ethernet cable from the PoE network switch Source to the LAN/PoE socket on the back of the TSE40. Controller Control Plate / Control Plate / Touchscreen Wallstation...
- Page 4 Control Plate / Touchscreen Wallstation Wallstation If the TSE40 is the last device on the network a 120ohm termination resistor will need to be added iCAN between CAN-H and CAN-L (White & Blue). These are included in the SW3 Kit.
Need help?
Do you have a question about the TSE40 and is the answer not in the manual?
Questions and answers