Table of Contents
Advertisement
OPERATION
Preparation
Set NORMALICATY selector to:
NORMAL for VHF and UHF programs.
CATV for cable TV programs.
Panel opened
NORMALI/CATV selector
1 Depress POWER to turn on the TV.
The channel number will be displayed on the screen
and the SLEEP lamp will light up for several seconds.
2 Select channels in one of the following two ways.
e Press the numeral(s) of the channel and then press
ENTER.
e.g. To select channel 6, press 6 and then ENTER.
To select channel 125, press 1, 2, 5 and then
ENTER.
If you pressed a wrong numeral, wait for a few
seconds and it will disappear. Then try again.
e Press CH "+" for higher-numbered channels and "—"
for lower-numbered channels. Preset channels will
appear in sequence. (For presetting desired channels,
see "PRESETTING CHANNELS")
The channel! display will remain on the screen for a few
seconds. To keep the display on the screen, press
DISPLAY.
3 Adjust volume and picture to your preference, if
necessary.
Press VOL "+" to increase volume, or "—" to decrease it.
Press PICTURE "+" to increase picture contrast, or "—"
to decrease it.
Connect to the MPX OUT jack on the rear of the TV a
special adaptor (not supplied) for multichannel TV sound
(stereo or bilingual) broadcasts.
Before connecting the adaptor, make sure that the power
to each piece of equipment is turned off.
weber
ere
oon
Advertisement
Table of Contents
