Whistler GPS100 Quick Start Up Manual

QUICK
START-UP GUIDE
P/N 501030 © 2003 The Whistler Group, Inc.

SET UP

SETTING
Press ,
Select "Setting", press
to change backlight, navigation mode,
NMEA output, map direction and
units (miles vs. kilometers).
NAVIGATION
CHANGE TO
SIMULATION MODE
From Satellite Page, press
to "Stop Navigation", Press

SELECT NAVIGATION MODE

From Satellite Page, press
to "Navigation", Press
INTRODUCTION
Dear Whistler Owner,
Thank you for purchasing the
Whistler Galileo™ GPS. Please take
time to read this guide, see our
Frequently Asked Questions on GPS
at www.whistlergroup.com, or call
Customer Service at 800-531-0004,
M-F 8am-5pm CT, for additional
assistance with your Galileo.
Sincerely,
The Whistler Group
THE WHISTLER GROUP, INC.
13016 N. Walton Blvd.
Bentonville, AR 72712
TEL (479) 273-6012 Fax (479) 273-2927
www.whistlergroup.com
NAVIGATION

TO SET A WAYPOINT

From Map Page move
to a chosen location,
Press and hold
To use default name press
To rename, press to name field,
Press , up/down to field through
alphabet, left/right to next letter,
Press
SATELLITE PAGE
Displays satellites
available, battery
status, location
coordinates, signal
strength and
backlight on/off.
SET UP
BATTERIES/
COMPACT FLASH (CF) CARD
Remove the battery compartment cover,
insert Compact Flash Card and insert 2 AA
batteries. Note: The CF card is for detailed
mapping only.

TURNING ON

Press for 2 seconds
VERTICAL/HORIZONTAL SCREEN
Press and hold

ADJUSTING CONTRAST

From Satellite Page,
move the to the left or right
Press when finished.
NAVIGATION

MAP PAGE

Displays current
position and
coordinates with
"Zoom In and Zoom
Out" options.

TRIP PAGE

Displays information
as you travel, such as
compass heading,
speed, track, odometer,
trip time, altitude,
speed, location, time
and date.
SET UP
BACKLIGHT
Press to turn on or off.
See "Setting" to change on time.

SET TIME

Go to Trip Page
Press Press ,
Move up to Hour
Press ,
Press to correct time
Press Move
to Press
NAVIGATION

COMPASS PAGE

Displays current
direction, distance and
time to next waypoint,
route, and final
destination. (picture
shown displays route
feature on.)
TRACK LOG-ON
(BREAD CRUMBS)
Leaves a trail behind
to help you find your
way back.