Table of Contents
Advertisement
Troubleshooting
Symptom
Cause
No power.
The power cord is disconnected.
The battery is discharged.
The power is on,
No disc is inserted.
but the unit does
The operation mode is not select-
not work.
ed correctly.
No picture.
The TV is not set to receive the
signal from the unit.
The video cable is not connected
securely.
The LCD mode is set to [Off].
No sound.
The equipment connected with
the audio cable is not set to
receive the signal from the unit.
The volume is set to minimum.
The AUDIO options are set to the
wrong position.
The unit does
An unplayable disc is inserted.
not start play-
back.
The rating level is set.
The remote
The remote control is not pointed
control does not
at the remote sensor on the unit.
work properly.
The remote control is too far from
the unit.
Specifications
Correction
General
Power requirements
Plug the power cord into the wall
Power consumption
outlet securely.
External Dimensions
Recharge the battery.
Net Weight (Approx.)
Insert a disc.
Operating temperature
Operating humidity
Use MODE button to select the
Laser
operation mode. (Page 7)
TV system
Select the appropriate video input
mode on the TV.
Signal system
Connectors
Connect the video cable securely.
Audio/Video Output
- Video: 1.0 V (p-p), 75 Ω, sync negative
Select a LCD mode other than
- Audio: 1.5 Vrms (1 KHz, 0 dB)
[Off].
Earphone terminal
Select the correct input mode of
Antenna Input
the audio amplifier.
Channel coverage
Liquid Crystal Display
Use the volume controller to
Panel size
adjust the volume.
Projection system
Set the AUDIO settings to the
Driving system
correct position.
Resolution
Insert a playable disc. (Check the
Accessories
disc type and regional code.)
• RCA Video/Audio cable
Change the rating level.
• AC Adapter (MPA-630)
• Automotive Adapter (DPDC1)
Point the remote control at the
• Remote Control
remote sensor of the unit.
• Battery for Remote Control (Lithium Battery)
• RF Antenna Cable Hub
Operate the remote control closer
• External Antenna
to the unit.
• Carrying Bag (DP461D only)
• Headrest Mounting Bracket (DP461D only)
Designs and specifications are subject to change without
prior notice.
DC 12V
12W
207 x 39 x 168 mm (W x H x D)
0.85kg
5 °C to 40 °C
5 % to 90 %
Semiconductor laser
PAL (B/G, /I, D/K) or
SECAM (B/G, D/K)
PAL
ø3.5mm mini jack x 1
ø3.5mm stereo mini jack x 2
75 ohms (VHF / UHF)
Analog (VHF/ UHF): 1-125
7 inches wide (diagonal)
R.G.B. stripe
TFT active matrix
480 x 234 (WQVGA)
17
Advertisement
Table of Contents
