Table of Contents
Advertisement
14 Basic settings
You can configure the basic settings for your appliance to meet your needs.
14.1 Overview of the basic settings
Display
Setting
Childproof lock
Audible signals
Energy consumption display
Shows the total energy consumption
between switching the hob on and off in
kWh.
The accuracy of the display depends on vari-
ous factors such as the voltage quality of the
power supply.
Automatic switch-off of the cooking zones.
Duration of the timer end signal tone
Power limitation
Enables the total power of the hob to be lim-
ited, if necessary, based on the conditions of
your electrical installation. The available set-
tings depend on the maximum power of the
hob. You can find precise information on the
rating plate. If the function is active and the
hob has reached the set power limit, is dis-
played and you cannot select a higher power
level.
Time for selecting the cooking zone
powerMove
Allows the default power levels to be
changed.
Cookware test
You can use this function to test the quality
of the cookware.
Restoring factory settings
Factory setting
1
14.2 To go to the basic settings
Requirement: The hob must be switched off.
To switch on the hob, touch
1.
Within the next 10 seconds, press and hold
2.
seconds.
.
for 4
Value
1
- Manual.
Automatic.
– Switched off.
– Confirmation and fault signals are switched off.
– Only the fault signal is switched on.
– Only the confirmation signal is switched on.
– All signal tones are switched on
1
– Switched off.
– Switched on.
1
– switched off.
- - minutes until the appliance switches off auto-
matically.
1
– 10 seconds
– 30 seconds
- 1 minute
- Switched off. Maximum power of the hob
- 1000 W. Lowest power setting.
. - 1500 W.
...
- 3000 W. Recommended for 13 A.
. - 3500 W. Recommended for 16 A.
- 4000 W.
. - 4500 W. Recommended for 20 A.
...
- Maximum power of the hob.
- Unlimited: You can adjust the last selected cooking
zone without having to select it again.
– Limited: You can adjust the last selected cooking
zone within 10 seconds after selecting it. After this time,
you must select the cooking zone again before adjusting
it.
- Preset power level for the front cooking zone.
. - Preset power level for the rear cooking zone.
- Not suitable.
- Not optimal.
- Suitable.
1
- Individual settings
.
- Factory settings.
Product information
Directory for the technical after-sales
service (TK)
Production number
Basic settings en
1
.
1
.
1
Display
11
Advertisement
Table of Contents
