AquaScape 54003 Installation Instructions

I N S T A L L A T I O N
Thank you for choosing the Aquascape
Waterfall Foam Gun Applicator. At Aquascape,
we connect people to water the way nature
intended. Since 1991, we've been creating and
field-testing water features in order to provide you
with the most reliable products and best value in
the water gardening industry.

Instructions

STEP 1

• Before putting a can of foam on the gun, press the trigger
down to release any air trapped in the barrel.

STEP 2

• Shake foam can and thread the can into the gun.
NOTE: do not overtighten

STEP 3

• Squeeze trigger to allow foam to fill the barrel.

General Maintenance

• Nozzle tip can be cleaned using a wire brush or similar material. DO NOT scrape on rough surface such as concrete or rocks.
• If the gun barrel is clogged, use a can of Foam Gun Cleaner (#22011) to flush out the barrel.
• If the ball valve, located in the gun where the can is attached, becomes stuck, use a thin object such as a pencil, to press down
on the ball to release.
WARNING: Always keep a can of foam on the gun. Failure to do so will cause foam to harden in the barrel and
clog the gun.
facebook.com/aquascapeinc
youtube.com/aquascape4
pinterest.com/aquascapeinc
I N S T R U C T I O N S
Waterfall Foam Gun
Applicator
Waterfall Foam Gun Applicator
Item #54003

STEP 4

• Adjust the flow by tightening or loosening the flow-
adjustment screw found on the back of the gun.

STEP 5

• When finished, tighten the flow-adjustment screw fully until
trigger is locked.
For more information about our company or products, please visit our website at
aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426
©2023 Aquascape, Inc. • All Worldwide Rights Reserved 10/23