Shoe Assy (Sh1); Main E Assy - Sony HVL-F60M Service Manual

HVL-F60M
2-3.

SHOE ASSY (SH1)

2-4. MAIN E ASSY, CHARGING CAPACITOR ELECTRICAL DISCHARGE PROCESSING
6 two tapping screws
(M2 4.5)
qa Discharge the charging capacitor.
Note: When checking the unit, the electrical discharge is necessary for the electric shock prevention beforehand.
Connect the resistor attached wires of the figure below to the MAIN board for around ten seconds.
1 k 1
(Part No. 1-215-869-11)
wire
rap ins lating tape.
6
1 two tapping screws
(M2 4.5)
3 shoe flexible board
2 Remove the shoe assy in
the direction of an arrow.
– Bottom side view –
A
7 Remove the main E assy in
the direction of an arrow.
resistor
wire
1 two tapping screws
(M2 4.5)
5 shoe assy
(SH1)
4 FA flex cable
5 Move the radiation block in
the direction of an arrow A.
9 connector
8 connector
3 Open the connector
cap.
– Bottom side view –
4 tapping screw
(M1.4 6)

0 main E assy

2 assist light panel
1 three claws
C board