Zinwell NextGen ZAT-600B Quick Start Manual

Programming the Remote Control
The remote is capable of controlling up to six basic functions of most
TVs and audio devices (volume, mute, power, input). Use the instructions
below for programming the six designated learning keys to operate your
TV or audio device.
Programming:
1. Press and hold the black "TV POWER" button for 3 seconds until the red LED changes from
flashing to solid. The solid red LED indicates the remote control is in learning mode.
2. Once in learning mode, press and release one of the six learning keys to be programmed.
The indicator light will change from solid to slow flashing.
3. Point the front of the TV remote control at the front of the Zinwell remote (about 1~2in). Then
press and hold any button on the TV remote control to be learned by the Zinwell remote. After
the signal is learned, the indicator light will flash 3 times quickly then you can release the button.
4. Press OK button of the Zinwell remote to save programming.
Repeat steps 2, 3 and 4 to learn other keys in the TV area. Press OK button of the Zinwell
**
remote to save programming.
Note:
1. During the learning process, if you wait for more than 10
seconds at any time, it will automatically exit the learning
state.
2. During the learning process, press any button outside the
learning area at any time to exit the learning state directly.
3. The two remote controllers must not shake during learning.
Learning Keys:
TV
VOL
Red LED Feedback:
1. Solid LED: Remote is in learning mode,
awaiting a key to be selected for
programming.
2. Slow Flashing LED: Remote is awaiting from
TV remote control.
3. LED flashes 3 times: Learning is successful.
TV Remote Control
TV
About 1~2in