Whirlpool Gold GU2800XTV User Manual page 6

OPTION SELECTIONS
OPTIONS DISH LOAD TYPES
Loads containing
tough, baked-on
food.
To sanitize your
dishes and
glassware in
accordance with
NSF/ANSI Standard
184 for Residential
Dishwashers.
For best drying
results, dry dishes
with heat.
To run your dish
washer at a later
time or during off-
peak hours.
Control Lock To avoid unintended
use of your
dishwasher, or cycle
and option changes
during a cycle.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To cancel wash cycle
To follow the
progress of your
dishwasher cycle
To follow the
progress of your
dishwasher cycle
To follow the
progress of your
dishwasher cycle
To follow the
progress of your
dishwasher cycle
6
DESCRIPTIONS
Increases the target water temperature during the wash portions of
the cycle.
Adds heat, wash time and water to the cycle.
Raises the water temperature in the final rinse to approximately
155°F (68°C). This high temperature rinse sanitizes your dishes
and glassware in accordance with NSF/ANSI Standard 184 for
Residential Dishwashers. Certified residential dishwashers are not
intended for licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the cycle.
Turn OFF when loads contain plastic dinnerware that may be
sensitive to high temperatures.
This option with the use of rinse aid will provide the best drying
performance.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press Delay until reaching the
desired hours for the delay to start. Press START/RESUME. Close
the door firmly.
To turn on Lock, press and hold Heated Dry for at least 4 seconds.
To turn off Lock, press and hold Heated Dry for at least 4 seconds.
When Control Lock is lit, all buttons are disabled. If you press any
pad while your dishwasher is locked, the light flashes 3 times. The
dishwasher door can be opened while the controls are locked.
COMMENTS
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
The Washing indicator glows at the start of the first fill of any cycle (except Rinse Only) and
remains on until the end of the main wash cycle.
The Drying indicator glows during the drying portion of each cycle (except Speed Wash and
Rinse Only).
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the "Sanitized"
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to
the required temperature. The light goes off when you open and close the door or press
CANCEL.
USE WITH:
Adaptive Wash, Pots &
Pans or Normal cycle
Adaptive Wash, Pots &
Pans or Normal cycle.
Only these sanitization
cycles have been
designed to meet the
NSF/ANSI requirements.
Available with any cycle
except Rinse Only.
All cycles, except Rinse
Only
Anytime