PSC Active RF Matrix Rack Manual page 7

the rear panel of the unit located right next to each RF input BNC connector for your
convenieance.
RF Inputs showing LEDs which Indicated which BNCs are active (RF Assigned) and which BNCs have
Remote Antenna Power applied.
RF METERING:
RF Signal Level Meters
There are two RF signal level meters on the front panel of the PSC Active RF Matrix. These
meters monitor the RF signal strength of the RF that is going out of the unit via the SMA
connectors to your wireless receivers. They display signal levels form approximatey -56dB up
to +10dB. They can be used for overall RF signal monitoring while in normal use or for RF signal
level monitoring while doing site setups. For example, if you are want to test the RF signal
strength of your various RF Zones before production starts for the day, you can switch on only
that one particular RF zone and then use the meters to monitor that one RF zone. You can
repeat this quick test for any and all other used zones, one zone at a time.