Sony FD Trinitron WEGA KV-32XBR400 Operating Instructions Manual page 45

Other Information
Programming the
Remote Control
The remote control is preset to operate Sony brand video equipment.
Sony Switch Position Programmable
Equipment on Remote Control Code Number
Beta, ED Beta VCRs VTR1 303
8 mm VCR VTR2 302
VHS
VCR .......... VTR3 .....
301
DVD Player DVD / MDP
751
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedures to
program the remote control.
_:_ Theequipment must have infrared (IR) remote capability in order to be usedwith the
remote control.
To check if the code number
works, after step 5 aim the TV's
remote control at the component
and press the POWERbutton that
correspondswith that component. If
it responds,you're done. If not, try
using the other codes listed for your
component.
Turn to "Programmable Codes" on page 43, and find the three-
digit code number for your equipment. If more than one code
number is listed, use the number listed first to complete the
following procedure.
_:_ You must perform step 3 within I0 secondsof step 2, or you must start again from
step 2.
2
Press CODESET.
3 Move the slide switch to the desired input.
4 Enter the three-digit code number.
5 Press ENTER.
Tips
[]
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
If you enter a new code number, the code number you previously
entered at that setting is erased.
In some rare cases, you may not be able to operate your
equipment with the supplied remote control. In this case, use the
equipment's own remote control unit.
Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
42