ZORO 2XZG1 Operating Instructions & Parts Manual

Pin &
Hinge bar
Pin &
Washer
Pin & Washer
Pin,
Hinge bar
(C)
pen or pencil.
11. Drill holes and insert the appropriate bolts to mount the locking bar (B).
12. Pull the door (A) into the locking bar (B), and insert a padlock. (See
Fixing bar (E)
13. When moving gate, please use fixing bar (E) to lock for safety, please see
Picture 3
2XZG1/ 2XZG1
Manufactured for Grainger International, Inc. Lake Forest, IL 60045
Figure 5
OPERATING INSTRUCTIONS & PARTS MANUAL (OIPM)
Folding Gate (2XZG1/2XZG2)
Closed Position
Locking Bar (B)
CASTER
Figure 1
1.
2.
3.
4.
5.
6.
(D)
Figure 3
with lead anchors.
7.
8.
9.
Figure 4
10. Mark though the mounting holes of the locking bar (B) with a
Pin &
Hinge Bar
Pin &
Washer
Stand folded gate against the doorframe where you intend to
mount it. (See 1)
Figure
Mark center of hole on floor 1.5" away form wall to fit 5/8" pin
at bottom of gate. (See
Figure
Drill 3/4" hold in floor.
Place washer (D) over 3/4"hole.
Put gate (A) through washer and into hole. (See
Install hinge bar (C) on wall. Mark the mounting surface
through the holes in the hinge bar with a pen or pencil.(See
1 & 4) For mounting into:
Figure
Wood: use 5/16" × 2" Lag Bolts.
Steel: drill and tap for 5/16" × 1" Bolts.
Brick or concrete: 5/16" × 2" Lag Bolts in 3/8" holes
Drill appropriate size holes in the mounting surface.
Mount the gate (A) by inserting the appropriate blots through
the hinge bar.
Stretch the gate (A) across the opening. Line up the locking
bar with a pen or pencil. (See
Open Position
Locking
Bar (B)
Caster
Figure 2
3)
Figure
2)
Figure
2)
Figure
5.
Figure
3)