Table of Contents
Advertisement
●
Camcorder assembly
●
Repeat the above steps inversely to disassemble the camcorder.
Step ❶ : As shown below, fit the
camcorder with the right side of the
headband and install the set screw.
Step ❷ : Screw up the set screw
clockwise as shown in the diagram.
Step ❸ : Adjust the correct angle of
the camcorder and use the small
spanner to tighten the set screw.
Step ➍ : Correctly insert the rubber
cap into the set screw to finish the
installation.
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EP7 Pro and is the answer not in the manual?