Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Western Digital WDG1S5000
Summary of Contents for Western Digital WDG1S5000
- Page 1 My DVR Expander ™ Quick Install Guide...
-
Page 2: Before Getting Started
Before Getting Started Kit Contents Kit Contents • DVR Expander • eSATA cable • AC adapter • Quick Install Guide Handling Precautions CAUTION: This product contains no user-serviceable parts. Refer servicing only to DVR Expander authorized WD personnel or an authorized WD service center. •... - Page 3 Using My DVR Expander with TiVo Connecting the DVR Expander 1. Power off the compatible TiVo Note: For a list of compatible TiVo DVRs, visit www.tivo.com/expand. 2. Connect the eSATA cable to the DVR Expander and TiVo 3. Connect the AC power cord to the DVR Expander and electrical outlet. The power LED illuminates. 4.
- Page 4 Expander does not allow you to play your recordings on a different DVR. Because each recording is distributed equally between the DVR’s internal drive and the DVR Expander, you cannot gain additional storage by using more than one DVR Expander. You should only remove the DVR Expander if you wish to stop using it.
-
Page 5: Frequently Asked Questions
Q: What is a DVR Expander? A: The DVR Expander is a device for adding additional storage capacity to your eSATA port-equipped DVR, and adds up to 300 hours of additional Digital SD recording time depending on the system and signal quality. - Page 6 Q: Can I disconnect the DVR Expander from a DVR? A: Do not unplug or disconnect the drive while the DVR unit is plugged in or operating. To safely disconnect the drive from a DVR, first unplug the DVR from its power source, wait 10 seconds, and then disconnect the DVR Expander.
- Page 7 Using My DVR Expander with Scientific Atlanta DVRs Connecting the DVR Expander to a DVR 1. Check the recording space on your digital video recorder (DVR). Write down the percentage of used and available space, then power off the DVR and disconnect its power cord. 2.
- Page 8 Disconnecting the DVR Expander CAUTION: Always unplug the power cord from the electrical outlet before disconnecting the AC adapter from the DVR Expander. 1. With the DVR off, disconnect its power cord either from the back of the DVR and from the electrical outlet. 2.
- Page 9 Q: What is a DVR Expander? A: The DVR Expander is a device for adding additional storage capacity to your eSATA port-equipped DVR, and adds up to 300 hours of additional Digital SD recording time depending on the system and signal quality.
- Page 10 Q: Where should I place the DVR Expander drive in an entertainment center? A: It is up to you. However, do not obstruct the front panels of the DVR Expander drive as this will reduce its cooling airflow. Note: Some electronic components have vent holes in the tops and sides allowing heat to escape. Do not stack the DVR Expander on top of, or block the vent holes of, other components in your entertainment center.
-
Page 11: Warranty Information
U.S.A. Western Digital, WD, and the WD logo are registered trademarks; and My DVR Expander is a trademark of Western Digital Technologies, Inc. TiVo is a registered trademark of TiVo Inc. or its subsidiaries in the United States and/or other countries.
Need help?
Do you have a question about the WDG1S5000 and is the answer not in the manual?
Questions and answers