LG AMNW09GSJB1 Owner's Manual page 7

• Servicing shall only be performed as recommended by the equipment
manufacturer. Maintenance and repair requiring the assistance of
other skilled personnel shall be carried out under the supervision of the
person competent in the use of flammable refrigerants. (for R32)
• The information contained in the manual is intended for use by a
qualified service technician who is familiar with the safety procedures
and equipped with the proper tools and test instruments.
• Failure to read and follow all instructions in this manual can result in
equipment malfunction, property damage, personal injury and/or death.
• The appliance shall be installed in accordance with national wiring
regulations.
• When the power cord is to be replaced, the replacement work shall be
performed by authorized personnel using only genuine replacement
parts.
• This appliance must be properly grounded to minimize risk of electric
shock.
• Do not cut or remove the grounding prong from the power plug.
• Attaching the earth wire to the power outlet cover screw does not
ground the appliance unless the cover screw is metal, uninsulated, and
the power outlet is grounded through house wiring.
• If you have any doubt whether the air conditioner is properly grounded,
have the power outlet and circuit checked by a qualified electrician.
• The refrigerant and insulation blowing gas used in the appliance
require special disposal procedures. Consult a service agent or a
similarly qualified person before disposing of them.
• If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified person in order to avoid a hazard.
• Appliance shall be disconnected from its power source during service
and when replacing parts.
• Supply and communication cable of appliances shall not be lighter than
polychloroprene sheathed. (Code designation 60245 IEC 57)
• The appliance shall be stored in a well-ventilated area where the room
size corresponds to the room area as specified for operation. (for R32)
SAFETY INSTRUCTIONS 7