Kenwood TS-830S Instruction Manual page 12
Hide thumbs
Also See for TS-830S:
- Service manual (71 pages) ,
- Instruction manual (39 pages) ,
- Operating manual (6 pages)
Advertisement
@ COOLING FAN ©
@ RF VOLT CONTROL @
@ ANTENNA CONNECTOR
@ BIAS CONTROL @
® GND LUG
© SG SWITCH @
® KEY JACK @
@ ANTI VOX CONTROL @
( SPEAKER JACK ®
@® IFOUT1®
@® IFOUT2®
@ EXTERNAL VFO
CONNECTOR
@ XVERTER CONNECTOR
(@® REMOTE CONNECTOR
@ AC POWER CABLE
3.2 REAR
PANEL
1. COOLING
FAN @
This fan cools the RF amplifier section to insure reliable and
efficient operation.
2. RF VOLT CONTROL @®
This adjusts the RF output meter reading.
Set for 2/3 scale
reading during CW transmission.
3. ANTENNA
CONNECTOR
This
SO-239
coax
connector
should
be attached
to a
suitable 50Q antenna for transmitting and receiving.
4. BIAS CONTROL
@®
This adjusts the bias voltage to the (6146B) amplifier tubes.
Clockwise
rotation
increases
the
idling
plate
current.
Section 4 describes adjustment to 60 ma.
12
(@® AC FUSE
5. GND
(GROUND)
LUG
6. SG SWITCH
@
This slide switch controls the screen grid voltage to the final
7. AC POWER
CABLE
8. KEY JACK
@
Using shielded line, connect a key to this 1/4" phone jack
for
CW
operation.
Key
open-terminal
voltage
is
approximately
—65V.
Advertisement
