Panasonic Omnivision PV-DM2794 Operating Instructions Manual page 68

Tv / dvd / vcr combination
Hide thumbs Also See for Omnivision PV-DM2794:
Table of Contents

Advertisement

Check t he following p oints o nce again ifyouarehaving t rouble w ithyour u nit.
,_,1_j_ ,
,_:-_,
Completely
insert Power Ptug into an AC outlet.
I3
No power.:.
Set POWER button to ON.
1I-I2
Auto power-off (shut off) occurs after about 5 min. in DVD mode
Powe[ turns itself off.i:
with no operation, or if there is no broadcast signal in TV or
45-46
Playback mode. Turn the power back on.
Make sure your antenna system (TV or CABLE) is correctly set.
I4
Completely
insert Power Ptug into an AC outlet.
I3
Set POWER button to ON.
11-12
Adjust BRIGHTNESS,
SHARPNESS,
and PICTURE controls in 28-29
the SET UP Video Adjustment.
Adjust VOLUME
control.
22
Adjust SHARPNESS
and PICTURE controls in the SET UP
Video Adjustment.
28-29
Adjust TINT and COLOR controls in the SET UP Video
Adjustment.
28-29
Install a directional antenna.
I4
Make sure the selected channel is in unit's memory.
I9
Only the channel being recorded can be viewed on this unit.
31
Make sure your antenna system (TV or CABLE), is correctly
I4
set.
Make sure cassette record tab is intact.
8
Check that clock is set to current time and date.
45
Make sure DSS/CABLE
box (if used) is left on and tuned to
I4
channel to be recorded.
Set recording Start/Stop
times correctly.
34-35
Timer recording may not be performed
or continued
if a power
interruption
of more than 1 minute occurs before or during a
Timer Recording, even after power is restored.
Adjust TRACKING
control in either direction.
37
Try Head Cleaning.
8
Make sure VCR LOCK is set to off.
37
_iii
i_
i
ii
i i
i
Unit Cannot be
controlled.::
IACTION,
PLAY,
SELECT, SET POWER,
etc. buttons cannot be
selected..:
Aim Remote directly at the remote sensor on the unit. Avoid any I2
object blocking signal path.
Inspect the remote batteries.
8
Make sure VCR LOCK is set to off.
37
Exposing unit remote sensor to direct fluorescent
or outdoor
light may cause signal interference.
I2
Press TV/VCR for TV-VCR mode.
I2
Press DVD for DVD mode.
I2
Check remote batteries.
8
68

Advertisement

Table of Contents
loading

Table of Contents