Connecting The Power - Onkyo TX-8211 Instruction Manual

Connecting the power
Before plugging in the unit, confirm that all connections have been made properly.
Before turning on the power, be sure that the VOLUME knob is fully turned counterclockwise.
Turning on this unit's power may cause a momentary power surge, which might interfere with other electrical equipment, such as comput-
ers. If so, use a wall outlet on a different circuit.
U.S. and Canadian models:
Plugging the TX-821 1's power cord into an AC outlet puts the
POWER switch unit in stand-by status (the STAND-BY indicator is lit). Pressing
the POWER switch turns on the unit and lights up the display. If
this switch is pressed again, the unit returns to the stand-by status.
The POWER button on the remote contro! is used in the same way
as the POWER switch on the TX-8211.
d
Models other than U.S. and Canadian models:
After plugging the TX-821 1's power cord into an AC outlet, press
SYSTEM switch the SYSTEM switch to put the unit in power-on status (the unit
can be operated and its display is lit), The remote contro! cannot
be used to operate the TX-821 1 if the SYSTEM switch is not set to
ON.
When the SYSTEM switch is set to ON, pressing the POWER but-
ton on the remote control switches the TX-8211 between stand-by
status (the STAND-BY indicator is lit) and power-on status (the
display will light up).
Pressing the SYSTEM switch on the TX-8211! to set it to OFF
turns off the unit. (When the SYSTEM switch is set to OFF, only a
small amount of power is used.)
i
12