Table of Contents
Advertisement
4.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 3 Attaching the device to a rack
1.
Bracket, front right
2.
Screw, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the rack
NOTE
Do not use the rear brackets for the Extreme Networks 6505, 6510, or 6520 switches.
Complete the following steps to attach the rear brackets to the rack.
1.
Position the right rear bracket in the right rear of the device as shown in the following figure.
2.
Attach the brackets using three 10-32 x 5/8-in. screws and 10-32 retainer nuts.
3.
Repeat step 1 and step 2 to attach the left rear bracket.
1U, 1.5U, and 2U Mid-Mount Rack Kit for Two-Post Racks
53-1001273-11 Rev AA
Attaching the rear brackets to the rack
3.
Retainer nut, 10-32
13
Advertisement
Table of Contents
