Advertisement
Available languages
Available languages
BATTERY STATUS (See Fig. E5)
Before starting or after use, press the button beside
the power indicator light on the machine to check
the battery capacity. During operation, the battery
capacity will be indicated automatically by the battery
power indicator.
The indicator constantly senses and displays the
battery condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Five green lights (
) are
illuminated.
Two, three or four
green lights are
illuminated.
Only one green light
(
) is
illuminated.
No light is
illuminated.
EN
Only one light is
flashing twice per
cycle.
Only one light is
flashing three times
per cycle.
Only one light is
flashing four times
per cycle.
OPERATION
INSTRUCTIONS
WARNING! The charger and battery pack are
specially designed to work together so do
not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because of an electrical failure
and hazard will occur.
1. Bump-line feed system (See Fig. I)
The trimmer is equipped with a bump-line system.
Just bump the trimmer head while the machine is
Cordless Grass Line Trimmer & Brushcut-
ter, Attachment-Capable
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
almost depleted and needs
to be charged.
At least one battery is not
fully installed or battery may
be defective.
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Raise the cutting height or
push slowly.
running, new line will feed out.
2. Winding the trimmer line (See Fig. K)
Insert the replacement line through the eyelet and
feed it through the other side. Ensure both ends of
the line are even on each end of the trimmer head
(recommended 2m) and cut the line. Turn the dial
clockwise to wind the line around the spool until
about 19cm remains on either side.
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from your
trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for
storing the trimmer on the wall. (See Fig. N)
Store in a dry place where the trimmer and battery
can be protected from damage.
MAINTENANCE
Always remove the battery pack from your
trimmer after use.
Always check the product prior to being used for
any damage.
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C .
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C .
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted for
environmentally friendly recycling.
The plastic components are labeled for categorized
recycling.
EN
Advertisement
