Teltonika FMB1 Manual
Teltonika FMB1 Manual

Teltonika FMB1 Manual

Blue-tooth obd dongle

Advertisement

https://wiki.teltonika-gps.com/view/Template:FMB1_Blue-tooth_OBD_dongle
Template:FMB1 Blue-tooth OBD dongle
Contents

1 How to connect OBD II Blue-tooth Dongle to FMB device

1.1 Blue-tooth settings configuration

1.2 Connecting to Blue-tooth OBD II dongle

How to connect OBD II Blue-tooth Dongle to FMB device
Blue-tooth settings configuration
Following are the instructions on how to easily prepare Blue-tooth Dongle connection to the FMB
device. First we need to configure FMB device Blue-tooth settings. These are the required steps:
Go to
Blue-tooth
Turn on BT Radio by pressing
automatically be "FMB1YX_last 7 imei digits", you can leave it or type your own name.
Set Security Mode (position 4) to
list only
security mode but in this case you need to type external device MAC address in
Authorized Devices MAC List (position 7).
Set connection mode to
Set External Name as your Blue-tooth OBD II device name for proper device identification and
connection to it. In this example OBDII device name is "DONGLE", at least 2 characters are
needed to recognize it and connect to it. For better and faster adapter identification in
network you could enter a full device name. You could check your OBDII adapter Blue-tooth
name by scanning nearby Blue-tooth devices using a mobile phone or a computer with Blue-
tooth adapter.
Go to
OBD II
figure.
After all these steps press
figure).
Now you can disconnect FMB device from the configurator.
Connecting to Blue-tooth OBD II dongle
After this configuration OBDII dongle can be connected to FMB device. Turn on ignition, then turn
on its Blue-tooth connection. For pairing follow dongle instructions. OBDII device notification about
section similarly to as shown in the figure to the right (position 1).
Enable (visible)
OBDII
(position 5).
in main menu and select priority and others parameters visible in the following
Save to device
(position 2). "Local name" (position 3) will
PIN only
or
None
(you could select
to save configuration (position 8 in the top right hand
PIN + MAC list
or
MAC

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FMB1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Teltonika FMB1

  • Page 1 Template:FMB1 Blue-tooth OBD dongle Contents 1 How to connect OBD II Blue-tooth Dongle to FMB device 1.1 Blue-tooth settings configuration 1.2 Connecting to Blue-tooth OBD II dongle 1.3 Supported Blue-tooth OBD II dongles How to connect OBD II Blue-tooth Dongle to FMB device...
  • Page 2 paired Blue-tooth connection depends on the specific model. If you later restart FMB device it will automatically reconnect to this dongle. Supported Blue-tooth OBD II dongles FMB module works with Blue-tooth OBD II dongles which are based on ELM327 or STN1110 chips. Comparison of these chips is presented in the image below:...

Table of Contents