Advertisement
INSTALLATION MANUAL
1. In order to install the device, first remove the casing by following steps listed below:
•
unscrew the
screws*
securing the front panel with the rest of the heater,
•
remove the casing by lifting it upwards.
*Note: The number of mounting points may vary depending on the length of the unit.
2. After dismantling the elements listed in point 1, proceed to mounting the device
to the wall.
WALL MOUNTING
•
measure and mark on the wall the location of the fixing points,
•
drill the holes in the wall for expansion bolt and fixing screws supplied with
the device,
•
hang and level the back plate on the wall.
Projektował
Kreślił
Zatwierdził
Skala
Projektował
W.Kamińska
Nazwa rysunku
Kreślił
W.Kamińska
09-11-2023
Zatwierdził
FAN ASSISTED WALL-MOUNTED HEATER
Skala
Numer rysunku
1:2
VEZ-0012541
NVKN2-40/7,5/L
Note: When connecting units into continuous runs,
remember to level the entire run before screwing the
W.Kamińska
09-11-2023
heaters together!
W.Kamińska
09-11-2023
Numer rysunku
VEZ-0012541
1:5
Rewizja
Nazwa rysunku
NVKN2-40/7,5/095
Advertisement
